Microtech Gefell M294
Studio Condenser MicrophoneCardioid
Overview:
The M 294 extens the studio microphone System SMS 2000. The proved microphone capsules M 70 and M 94 form a unit with the modified microphone amplifier MV 200. These microphones are designed for a universal applications in professional recording and sound reinforcement and meet the requirements of modern technics.
The newly developed, transformerless circuit design substitutes the previous transformer for a symmetrical output stage. Its intrinsic noise and remarkably output capability emphasize the advantages of the microphone capsules M 70 and M 94. Microphone capsules with an extremly thin metal diaphragm enable brilliant sound transmission. The direction of maximum sensitivity is axial. The studio microphones are equipped with a wide range of accessories for many microphone mounting methods.
lt is possible to activate a 10 dB-attenuator pad for handling very high sound pressure levels. A sensitivity reduction for low frequencies can be utilized to suppress the proximity effect. The two switches are into the middle of the preamplifiers. The microphone is equipped with a standard 3-pin XLR connector fitting to a microphone cable, e.g. C70. The operation voltage is provided by 48 V phantom powering, according to the international standards DIN 45596 and IEC 268-15.
They are available in a satin nickel or a black matt finish.
Both condenser microphone capsules are pressure gradient transducer. The converter elements contain a nickel diaphragm with a thickness of less than 1 µm. The back-plate electrodes are Teflon-coated to increase operational reliability.
M294 The desired presence boost of ca. 5dB in the 8kHz range gives this microphone its special clarity. lt is recommended to use a popscreen and to switch on the microphone bass rolI-off for closerange applications.A windscreen can be utilized to enhance life-like recording.
Studio Condenser Microphone
M 294
Polar pattern
cardioid
Acoustical operating principle
Pressure gradient transducer
Frequency range
40 ... 18000 Hz
Sensitivity at 1 kHz
17 mV / Pa
Switch position "reduced bass roll-off" at 60 Hz
-15 dB
Rated impedance
150 Ω
Equivalent loudness level
due to inherent noiseCCIR 468-4
22 dB
DIN EN 60651
13 dB - A
Signal-to-noise-ratio
(re. 1 Pa at 1 kHz)CCIR-weighted
72 dB
A-weighted
81 dB
Max. SPL for THD ≤ 0,5 %
133 dB
with 10 dB preattenuation
143 dB
Total dynamic range of the microphones amplifier
120 dB
Current consumption (P 48, DIN 45596, IEC 268-15)
3 mA
Output connector
3-pin XLR-connector,
goldplated contacts
Weight
160 g
Dimensions (L x Ø )
166 x 21/25 mm